Switching from LR pages is amazing

[djoubert]

Hi,
Managing 2 Canon DSLR using LR feature I noticed the amazing diffences regarding the sequences, and it is amazing also about the total frame when switching:
With the 2.9, once the auto holly grail launched for each one, I switch from one to the other one with this sequence :
- clic on the red cross of the LR,

- then I get this picture where I can choose the dslr, choosing one show the LR page.

With the 3.0 ( beta7 ), once the auto holly grail launched for each one, I switch from one to the other one with this sequence :
- clic on the red cross of the LR,

Then I get the following page:

I need to clic on this icone :
Then I get this page :

I can choose the other dslr

Then I get

I have then to clic again on the LR button.
I did not made a lot of tests, but it seems that when I am moving from one dslr to the other one the shots are not taken into account …., at least the total frame is reset to 0 until the next shot.
Thank you to provide me with maybe another simple and sure way for switching.
Best regards
Dominique

[djoubert]

Hi Zoltan,
Could you have a look to what I reported.
With the sequences I reported , I am not confident in switching from one dslr to another one.
So far I do prefer to come back to the 2.9
I guess you can either explain how to proceed or maybe apply the same way to switch for the 3.0 as for the 2.9
Thank you very much
Dominique

[djoubert]

Hi,
Thank you if you could have a look to this post.
Are terre any chnage with the last release regarding this issue ?
best regards
Dominique

[hubaiz]

Will check.
I will implement a different behavior after AHG is started, it should bring up the manager interface instead of going to the device screen.

[djoubert]

Hi zoltan,
I saw that the behaviour regarding 2 dslr management has been changed.
It is perfect now with the V0.3.4 release
Thank you very much
Dominique