Hi Everybody,
I'm trying to install the server in a Rpi B2, even following the instructions here or in the Github, there's not any way it runs there. I'm sure I'm making something wrong.
1st method:
1. Flash latest Raspbian ISO from Rpi websited into a SD card
2. Run sudo apt-get update && apt-get upgrade
3. Reboot
4. Download and unzip the file (In /home/pi/Downloads/) downloaded from https://dslrdashboard.info/download/ras ... pi-v3-5-3/
5. Run sudo apt-get update && apt-get upgrade
6. Reboot
7. Enter to the folder /home/pi/Downloads/qDslrDashboard_V3.5.3_RPI/ and run sudo ./qDslrDashboard.sh
8. There's always a missing libraries..
2nd method:
1. Flash latest Raspbian ISO from Rpi websited into a SD card
2. Run sudo apt-get update && apt-get upgrade
3. Reboot
4. Run git clone git://github.com/hubaiz/DslrDashboardServer package/DslrDashboardServer
5. Run sudo apt-get update && apt-get upgrade
6. Reboot
7. Run sudo make menuconfig
8. Error message "no rule to make target 'menuconfig'"
- -
I'm not sure if the problem might be in the memory assigned to the GPU, when I set it to 512, the Pi won't boot. Once I set it for any lower value, it boots normally. Even gpu_mem_1024=512 let me boot the Pi, however when check the memory it says 64M.
Any suggestion where I'm making the mistake in the procedure?
Thanks in advance!
Raspberry Pi 2 Installation guide [Closed]
Raspberry Pi 2 Installation guide [Closed]
Last edited by PiKmera on 28 Aug 2017, 11:51, edited 1 time in total.
My work https://goo.gl/KdtxJk
Re: Raspberry Pi 2 Installation guide
Please check my answer here: viewtopic.php?f=5&t=1433&start=20#p6370
Re: Raspberry Pi 2 Installation guide
Thanks, I close this topic then.
My work https://goo.gl/KdtxJk