dslrdashboard.info

Hi,
Managing 2 Canon DSLR using LR feature I noticed the amazing diffences regarding the sequences, and it is amazing also about the total frame when switching:
With the 2.9, once the auto holly grail launched for each one, I switch from one to the other one with this sequence :
- clic on the red cross of the LR,

- then I get this picture where I can choose the dslr, choosing one show the LR page.

With the 3.0 ( beta7 ), once the auto holly grail launched for each one, I switch from one to the other one with this sequence :
- clic on the red cross of the LR,

Then I get the following page:

I need to clic on this icone :
Then I get this page :

I can choose the other dslr

Then I get

I have then to clic again on the LR button.
I did not made a lot of tests, but it seems that when I am moving from one dslr to the other one the shots are not taken into account …., at least the total frame is reset to 0 until the next shot.
Thank you to provide me with maybe another simple and sure way for switching.
Best regards
Dominique

Hi Zoltan,
Could you have a look to what I reported.
With the sequences I reported , I am not confident in switching from one dslr to another one.
So far I do prefer to come back to the 2.9
I guess you can either explain how to proceed or maybe apply the same way to switch for the 3.0 as for the 2.9
Thank you very much
Dominique

Hi,
Thank you if you could have a look to this post.
Are terre any chnage with the last release regarding this issue ?
best regards
Dominique

Will check.
I will implement a different behavior after AHG is started, it should bring up the manager interface instead of going to the device screen.

Hi zoltan,
I saw that the behaviour regarding 2 dslr management has been changed.
It is perfect now with the V0.3.4 release
Thank you very much
Dominique